AFS Clay Tester

Model 42131

AFS Clay Tester

Part number

AFS: # 0042131-ASM

Sand casting process

Clay Bonded Sand

Replacement parts

1,000ml Beaker Part Number: 0045818

Part Number: 0042131-ASM

Compressed Air: 6 bar (90 psi)
Water: Minimum incoming pressure 1.7-2 bar (25-30psi)
Power Requirements: 115/250 Volts, 50/60 Hz
Length: 232" / 584mm
Width: 13.5" / 343mm
Height: 11" / 279mm
Weight: 25lb / 11.4kg

AFS clay is the percentage of particles with a diameter less than 20 microns in a foundry sand sample. This includes active clay, dead clay, silt and inert fines. The sand sample to be tested must be prepared in the Rapid Sand Washer, Model No. 42119.

The AFS Clay Tester stirs a water and sand mixture into suspension and drains the overlaying liquid after a preset settling time. The time between cycles allows only particles larger than 20 microns to settle. If this process is repeated enough, all particles smaller than 20 microns will be removed. A command panel with a keyboard and a liquid crystal display (LCD) operates the tester. An on-board microprocessor can be programmed by the operator via the LCD for several advanced options, including number of cycles and type of sand to be tested. The AFS clay tester can also adjust settling times to compensate for temperature changes. A thermistor registers the water temperature during each settling period.

This data is received by the microprocessor which uses this information to correct the settling time for the next wash. The AFS Clay Tester is shipped with a pressure regulator, connecting hoses and 1000 milliliter beaker. The AFS Clay Tester also requires a Rapid Sand Washer, Model No. 42119 to pre-treat the sand sample prior to testing.

Key Advantages:

  • Includes an on-board microprocessor where the operator can preset the number of cycles and therefore does not need to be present while the device conducts the entire test.
  • The on-board microprocessor allows the operator to program the type of sand being used for the test.This is an important feature since the specific gravity of certain types of foundry sands differ from one another.
  • Contains minimum and maximum level electrodes that automatically control and stop the flow of water once it reaches its maximum level.
  • Contains a thermostat to record the water temperature during each settling period as well as electrodes to control the water level during cycling.
Manual

Manual

Get the guidance you need to optimize your sand testing process with ease and confidence.

Need More Information?

Contact Simpson to learn more about our innovative solutions and how we can support your operation. We are here to help if you have any questions or need assistance.

Need More Information

Related Content

Electronic Universal Sand Strength Machine - Model 42104 image

Electronic Universal Sand Strength Machine - Model 42104

Determines the strength properties of clay and/or chemically bonded foundry sand specimens.

Digital Absolute Permmeter - Model 42105 image

Digital Absolute Permmeter - Model 42105

A fully automatic system which measures the permeability of porous sand masses, both in compacted and loose states.

Digital Pneumatic Sand Squeezer - Model 42160 image

Digital Pneumatic Sand Squeezer - Model 42160

Designed to mimic the compressing action of an automatic molding machine in order to measure the effects the sand has upon its compaction abilities.

Wet Tensile Tester - Model 42112 image

Wet Tensile Tester - Model 42112

Determines tensile strength of the condensation zone that is created in all clay bonded molds during and after pouring.