Gas Pressure Measuring Device

Model PGD-E

Gas Pressure Measuring Device | SIMPSON

Part number

Metric: #592-806-850

Sand casting process

  • Cold Box
  • Hotbox/Warmbox
  • Nobake/Air-set
  • Shell/Croning

Specifications

Internal Calibration: n/a
Power Requirements: 230 Volts, 50 Hz

In order to accurately measure the gas pressure from foundry sands, this instrument can be used. To measure, a sand sample is heated then the gas pressure is recorded over time.

The success of castings is largely dependent upon this gas pressure and the generation time of the sand. During the pouring process, the cores and mold come into contact with liquid metal and are rapidly heated to high temperatures. As the temperature increases, the pressure inside the core increases due to the growing volume of core gas generated.

The removal of these hot gases, via the core structure, is hindered by the mold. If the quantity of gas reaches a level where it can no longer be vented by the permeability of the sand, the gas can be forced into the liquid metal and cause defects in the casting (e.g. porosity). Due to this impact of the core gas on the casting between the start of pouring and solidification, generation time is an important variable. To avoid casting defects, measurement of the gas pressure and judgement of generation time is extremely important to the metal caster.

Components Included: Measuring Tube & Attached Plug Coupling, Measuring Tube, Spiral Hose, (2) Plug Coupling, (10) Quartz glass tube, Glass Funnel, Test Glass Brush, Sample Holder, Quartz glass tube support, Monitor Cable (COM Cable), ADS16DAN Software and Carrying Case

Watch "How to videos"

Manual | Gas Pressure Measuring Device | SIMPSON

Manual

Get the guidance you need to optimize your sand testing process with ease and confidence.

Need More Information?

Contact Simpson to learn more about our innovative solutions and how we can support your operation. We are here to help if you have any questions or need assistance.

Need More Information

Related Content

Laboratory Sifter - Model 42106 image

Laboratory Sifter - Model 42106

Used to determine the fineness of foundry sands.

Electronic Universal Sand Strength Machine - Model 42104 image

Electronic Universal Sand Strength Machine - Model 42104

Determines the strength properties of clay and/or chemically bonded foundry sand specimens.

Test Pieces Blower - Model 42109 image

Test Pieces Blower - Model 42109

Used to make standard tensile, transverse (except cold box) and hot distortion test pieces.

Electronic Scratch Hardness Tester - Model 42145 image

Electronic Scratch Hardness Tester - Model 42145

Designed for chemically bonded sands, the scratch hardness of a mold or core is determined using this instrument. The instrument incorporates a four-point cutter that penetrates a finished core or mold surface when rotated.